Artistry AQUABRASION 매뉴얼 - 페이지 6

{카테고리_이름} Artistry AQUABRASION에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artistry AQUABRASION 10 페이지. Skincare device

Cleaning Method Please turn off the Device before cleaning.

Cleaning Mode after Using the SUCTION Mode

1. Place the Large Suction Nozzle on the Device.

2. Fill the Water Tank with water until it reaches the MAX limit line.

3. Turn the Device on by pressing the POWER Button then press and

hold the SERUM Button for 2 seconds to start the Cleaning Mode.

4. Turn the Dome Attachment upside down and securely hold it on

top of the Large Suction Nozzle.

* Hold the Device upright. If the Device is tilted too much, it will

beep and shut off. If this occurs, hold the Device upright and turn

on to continue cleaning.

5. When the water in the Water Tank is exhausted, press and hold

the POWER Button for 2 seconds to turn the Device off.

6. Hold the device upright and remove the Bottom Cap to empty the

Waste Tank.

7. Separate the Water Tank and place it on the Cradle's Water Tank Holder.

8. Remove the Large Suction Nozzle and gently rinse the Suction

Nozzles, Dome Attachment, and Bottom Cap with water.

9. Return the Device to the Cradle and allow all of the components

to completely dry.

How to clean the Waste Tank

1. Remove Bottom Cap and empty the Waste Tank.

2. Use the brush and dampen it to clean the Waste Tank walls

thoroughly and gently.

3. Return the Device to the Cradle and allow the Waste Tank to

completely dry.

NOTE:

• Avoid soap and excessive/aggressive wiping or brushing. It may

cause damage.

• Do not shake, tip, or lay the Device down when the Water Tank or

Waste Tank is filled with water. The Device should remain in the

upright position if either Tank still contains water.

• This is to protect the pump from water backflow if the Device is

tilted too much while the Waste Tank contains water.