Customidea GeoPic II 사용 설명서 - 페이지 6
{카테고리_이름} Customidea GeoPic II에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Customidea GeoPic II 20 페이지. Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro
페이지 인쇄GeoPic II basic operation
GeoPic II basic operation
Slide the GeoPic II into the hotshoe flash mount on your
camera, and with the camera off, connect the 10-pin
connector to the matching socket on the camera body.
The locking ring can be used to secure the connection.
Press and hold the function button for a second or two
and you will see the GeoPic II spring to life.
There are a number of different ways that the GeoPic II
can be powered up and powered down. When the
GeoPic II powers up, the status light will slowly turn on in
the colour corresponding to the last used mode. When
the GeoPic II powers down, the status light will slowly
turn off in the colour of the currently used mode. The
following table explains the different power up and
power down methods:
Power up method:
Press and hold function
button
Camera entering
metering state
Power down method:
Press and hold function
button
Auto off after inactivity
Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered
Details
Pressing and holding the function button on
top of the unit for approximately 2 seconds will
turn on the GeoPic II. You can disable this
power up method from the settings menu if
required.
The GeoPic II will turn on if the camera enters
its metering state. This will happen if you turn
on the camera, or if you press the shutter
release button to wake the camera up. You
can disable this power up method from the
settings menu if required.
Details
Pressing and holding the function button for
approximately 2 seconds will turn off the
GeoPic II.
The GeoPic II will turn off after a certain period
of inactivity from the camera, the default is 5
minutes. If required, you can disable this
power down method from the settings menu,
or change the period of inactivity to between 1
and 10 minutes.
trademarks or a trademark of their respective companies.
5