Artistry In Motion Big Shots 운영 및 유지보수 매뉴얼 - 페이지 9

{카테고리_이름} Artistry In Motion Big Shots에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artistry In Motion Big Shots 12 페이지. Wireless transmitter and receiver
Artistry In Motion Big Shots에 대해서도 마찬가지입니다: 로딩 및 발사 지침 (2 페이지)

페이지 인쇄

2.4

THE FIRE BUTTONS

These buttons are snap action dome switches under a sealed overlay, labeled

"Fire CH A" and "Fire CH B", respectively. They have a high spring constant

which requires a firm depression for actuation, decreasing the likelihood of

accidental depression.

The transmitter is idle while no buttons are pressed. Continuous transmission

occurs while "Fire CH A" or "Fire CH B" is pressed

Output firing pulses are stretched to a minimum duration of 1 second to ensure

that all cues fire reliably, even when the "Fire CH A" button is pressed for a

shorter period of time. Note that it is not necessary to wait for the completion of

the 1-second firing pulse period before firing subsequent cues. They can be fired

as fast as the operator can press the button, provided that each button

depression lasts at least 0.1 second.

2.5

THE TRANSMIT INDICATOR.

This is a high intensity red indicator, visible in direct sunlight, which lights

continuously while the transmitter is generating RF output. It is located between

the two buttons. It will light even if the battery voltage is below the low battery

detect threshold.

2.6

THE BATTERY.

Power is supplied from an alkaline 9-volt battery, accessible beneath a slide-out

door on the backside of the transmitter. This battery should be replaced when

required by conditions described in section 2.3 above. In order to prevent the

possibility of damage due to battery leakage, the battery should always be

removed if the transmitter is to be stored for a prolonged period. Damage due to

battery leakage is not covered under the warranty.

3.0

OPERATION AND MAINTENANCE.

This

section describes the recommended operating procedure and maintenance for the

transmitter-receiver system.

3.1

OPERATION.

3.1.1 PRE TEST: Before connecting the Big Shots® solenoid valve to the

Artistry In Motion, Inc.

Tel: 818.994.7388

Ver 08/20

receiver perform a reception test by observing the receiver battery light

while pressing the transmitter button. Be sure that the receiver is in the

"Safe" mode, and select Channel A on the channel select switch. Turn

the key on the Wireless Big Shots® Transmitter to "Armed" and press the

"Fire CH A" button. The receiver battery light will illuminate a solid green

when the transmit button is depressed. An assistant may be needed for

this test. If the receiver location will be fixed, determine the limits of the

range in the current environment, and position the transmitter and

19411 Londelius Street, Northridge, CA 91324

Fax: 818.994.7688

Website:www.artistryinmotion.com

Page 9