Customtronix RA3 설정 매뉴얼 - 페이지 2

{카테고리_이름} Customtronix RA3에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Customtronix RA3 4 페이지.

The "Engineering Menu" will come up, scroll (3) down to "Reset To Factory

Defaults" (4), press "Yes". Wait approximately one minute for the system to reboot.

Pic below show lower part of the "Engineering menu".

The best way to initialise a car after a factory reset is to remove the positive cable from

the cars battery for 5 minutes.

Re-connect the positive cable to the battery and turn ignition "On" and let the system

boot-up completely, then turn ignition "Off" open and close the door and wait for

approximately 1 minute for the car to shut down, this is to initialise all the modules and

drivers for the different hardware's, done.

DO NOT play around with the settings in the "Engineering Mode" as it can void the

warranty.

4. The FM-radio part has only Odd frequencies on following models MX,CA and NA, so if

you manually tune for "even" frequencies it will not respond.

5. If you have problem with you pin-code, remember that the pin-code is on the note

attached on top of the unit when it is returned after conversion.

6. For authorised Chrysler dealers It´s possible to check the pin-code from the serial

number of the navigation unit in the ERES system (Chrysler Electronics Repair &

Exchange System). To do that you must access "Dealer Mode" (a different menu

system separate from the "Engineering Mode").

2014-04-23

2 (4)

Continuing next page