Alula RE359 매뉴얼

{카테고리_이름} Alula RE359에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alula RE359 4 페이지. 360 motion sensor

Resolution Compatibles

360 PIR Motion Sensor

It is a commercial battery-powered ceiling mount sensor

with a 360 degree detection range.

Features

• 360° detection range with 62 distinct detection zones

• Range up to 40 feet in diameter

• Selectable pulse count 2 or 4

• Designed for commercial applications

• 5 year warranty

Enroll

all variants by entering their serial numbers into the

security panel. Alternatively, the sensor can be enrolled in

one of the following ways:

DSC®, Qolsys® and Interlogix® variants are enrolled by

placing the panel into enrollment mode, and then pulling

the battery tab or tampering the device.

Honeywell® and 2GIG™ variants are enrolled by placing

the panel into wireless enrollment mode and either

removing the battery tab while holding the tamper, or by

tripping the device three times. These sensors must be

enrolled as a "Loop 1" sensor.

Install

by screwing two #8 screws into the ceiling, leaving

1/4 inch of thread exposed. Next, slide the back plate over

the screws and rotate the back plate. Screw the #8 screw

through the wall tamper into the ceiling, ensuring that the

wall tamper screw is attached to something solid. Tighten

all screws until snug. Then, insert the square nut into the

square slit of the cover and start threading the #4 screw into

the side of the cover. Close the cover and conduct a walk

test. After testing, take the unit out of walk test mode and

close the cover again. Finally, finish threading the #4 screw

until it is snug.

Mounting Tips

• Avoid direct sunlight

• Avoid facing directly to AC or heating vents

• Avoid vapor or high humidity

• Avoid curtains, screens, etc. from blocking detection

• Do not install outdoors

Use your panel's installation guide to verify proper system setup.

360 Motion Sensor

alarms when motion is sensed.