Alula NanoMax RE122 설치 매뉴얼

{카테고리_이름} Alula NanoMax RE122에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alula NanoMax RE122 4 페이지. Door/window sensor, interlogix compatible
Alula NanoMax RE122에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

Resolution Compatibles

NanoMax

is the smallest full-featured security transmitter

in the industry. It is typically used to sense opening and

closings of doors and windows, but can secure just about

anything using its Strip & Stick external contact holes. It will

alarm when the magnet is pulled away from the NanoMax or

when the external contact is opened.

Features

• Quick peel and press mounting

• Small profile for a near invisible look

• Most flexible magnet positioning in the industry

• Strip & Stick external contact holes

• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode and

then sending an enrollment signal from NanoMax.

Options for sending an Enrollment Signal

• Remove the battery tab, which can be done

without removing the cover, OR

• Touch the magnet to the sensor 5 times within

5 seconds, OR

• Remove the cover to trip tamper

Install

by removing the adhesive paper and adhering the

NanoMax and magnet on a door or window. Make sure to

align the alignment marks on the NanoMax and magnet

when mounting. Alternatively, NanoMax can be used with an

external contact instead of the reed switch.

External Contact

• If you are using the external contact then you

cannot use the reed switch.

• Use a normally-closed contact because

NanoMax will transmit an alarm when it sees

the external contact open.

• Do not use end-of-line resistors.

• Connect the contact to NanoMax by inserting

the contact's wires into the two Strip & Stick

holes on the back of NanoMax.

• Additional wiring information can be found

by searching

wiring".

Use the panel installation guide to verify proper system setup.

RE122 NanoMax Door/Window Sensor

Interlogix

alula.net

for "external contact

Compatible