Alula RE657WF-R 매뉴얼 - 페이지 8

{카테고리_이름} Alula RE657WF-R에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alula RE657WF-R 12 페이지. Flat mount touchpad

• Users - manage device users directly from the touchpad (only the account owner can modify

users, internet access is required).

• Keypads - lists the panel's keypads

• Rename keypads by selecting an item on the list and holding it for 2 seconds

• Communication Test mode

• The Touchpad will begin testing communications and display "TESTING"

• After one minute, the Touchpad will show the result of the test which will be either

"GOOD," "FAIR," OR "POOR"

• If you get a "POOR" test result, try the test again from another location

• The table below lists the thresholds used to determine the outcome of the test

• If any statistic falls in the poor range, the test outcome is "POOR"

• If there are no poor statistics and any statistic is in the fair range, the outcome of the

test is "FAIR"

• If all statistics are in the good range, the outcome of the test is "GOOD"

Statistic

Wi-Fi Signal

Strength

Communication

Success Rate

Response Time

Average

• Check for updates - this will tell the panel to check for any system updates

• Z-Wave

• Join/Leave Another Z-Wave Network - the panel can be placed into Z-Wave inclusion or

exclusion mode to allow it to join/ leave existing Z-Wave networks.

• Soft Reset - a soft reset will reset the Z-Wave controller software. All Z-Wave devices will

remain enrolled.

• Hard Reset - this action will cause your Connect+ Z-Wave module to be restored back

to the default state. Warning: Performing this action results in all Z-Wave devices being

removed from this Z-Wave controller. To add them back, you will first need to exclude

them, and then include them again.

**PLEASE SEE Z-WAVE USER GUIDE FOR ADDITIONAL INFORMATION**

• About - lists information about the panel's installed hardware and software

Unit

GOOD

Over 39

Over 89

Under 200

FAIR

35 to 39

85 to 89

200 to 250

POOR

Under 35

Under 85

Over 250