CUTRA WC40000F25W 사용 설명서 - 페이지 5
{카테고리_이름} CUTRA WC40000F25W에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CUTRA WC40000F25W 17 페이지.
페이지 인쇄01
Pull the handle out inside the main body.
02
Press the power button of the main body for 1 to 2 seconds to turn the LED
on the face panel on. This turns the product into stand-by state.
(another push will turn the power button off.)
* The LED(green) on the handle is off.
03
At stand-by state, press the power button on the handle. This will cause
40,000 vibrations per second. The cutter only operates while being pressed.
* The LED(green) on the handle is on.
04
When used for more than 10 minutes, the product stops operating and goes into
stand-by state.
* The LED(green) on the handle is off under stand-by state. The inner temperature of the
handle gets higher while being used, turning into high temperature stationary state.
* The LED button of the handle does not turn on in high temperature stationary state.
* The stand-by state extends based on the handle power button.
* When the main body is on, the vibrating part continually creates sound waves so
the product must be turned off when not in use. In order to prevent putting the
handle into the main body unconsciously, the product is designed to beep.
03