Aluprof AM45-20/17-ER-P 프로그래밍 매뉴얼 - 페이지 5

{카테고리_이름} Aluprof AM45-20/17-ER-P에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AM45-20/17-ER-P 8 페이지.

페이지 인쇄
Aluprof AM45-20/17-ER-P 프로그래밍 매뉴얼
7. AUTOMATIC SETTING OF LIMIT POSITIONS
On the transmitter press
the „P2" button.
After a few seconds motor will
change operation direction to
opening diretion.
After overload mechanism
is activated motor will change
operation direction.
We reserve the right to any technical change.
Valid on 2022.01.27
PROGRAMMING MANUAL FOR AM45 MOTORS ER-P SERIES
The motor will make a short
move DOWN - UP.
After overload mechanism is
activated motor will make a move
„UP" - „DOWN"
After a few seconds motor will
change operation direction to
cloasing diretion.
Press the „STOP" and „UP".
Roller shutter opens.
The upper limit position has been set.
After overload mechanism is
activated motor will make a move
„UP" - „DOWN"
After overload mechanism
is activated motor will change
operation direction.
The motor automatically starts
moving in closing direction.
The lower limit position has been set.
5