Aluprof AM45-40/12-ER-P 프로그래밍 매뉴얼 - 페이지 3

{카테고리_이름} Aluprof AM45-40/12-ER-P에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AM45-40/12-ER-P 8 페이지.

Is important to adjust the sensitivity of the overload mechanism to the size of the roller shutter.

4. SWITCH TO PROGRAMMING MODE

Turn on the motor's power supply.

III

Press and hold "TOP" button.

5. MEMORIZING THE TRANSMITTER

Switch to programming mode

according to point 4.

For the AC116-04 transmitter, instead of the „UP" button, press the selected channel number twice.

We reserve the right to any technical change.

Valid on 2022.01.27

PROGRAMMING MANUAL FOR AM45 MOTORS ER-P SERIES

Press and hold the

programming button

on the motors head

for 2 seconds.

Press and hold the „STOP"

button for 5 seconds.

After 3 seconds, turn on the power to

the motor. Release the button.

Press the „UP" button.

The motor will make a short

move DOWN - UP.

The motor will make a short

move DOWN - UP.

The motor will make a short

move DOWN - UP.

The motor will make a short

move DOWN - UP.

Programming mode activated.

Programming mode

activated.

Programming mode

activated.

The transmitter has been added.