Aluprof DC 661 프로그래밍 매뉴얼 - 페이지 4
{카테고리_이름} Aluprof DC 661에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof DC 661 4 페이지.
페이지 인쇄
2.3. Settings days and hours for automatic controls
We only change the lifting and lowering time in the automatic control mode.
The difference between lifting and lowering must not be less than 32 minutes.
If the pause between each key press is longer than 10 seconds, the transmitter exits the setting mode. Leaving the time change
mode without saving is carried out by pressing the STOP key
Press and hold the „MODE / K„
button for 3 seconds to switch on
the automatic control
By pressing the „MODE / K-" -button
you can change to the
minutes settings
By pressing the „MODE / K-" key, you
go to the minute settings of the
reduction times. The minute symbol
will blink
4
DC 661 PROGRAMMING MANUAL
Press and hold the „MODE / K"
button for 3 seconds.
The lowering time appears on
the display
The operation of the "UP" and
„DOWN" keys changes
the minute settings
The operation of the „UP" and
„DOWN" keys changes
the minute settings
Press the „MODE / K-" button again.
The lift time will flash
By pressing the „P2" button, you go
to the hour settings of the reduction
times.
By pressing the „OK / K +" button in
1 or 3 mode you change the days of
the week. We repeat these activities
to set the time
The operation of the „UP"
and „DOWN" keys changes
the hour settings
After setting all operating
times you should keep the
„OK / K +" - button pressed for about
3 seconds to confirm the changes
After setting all operating
times you should keep the
„OK / K +" - button pressed for about
3 seconds to confirm the changes
We reserve the right to any technical change. Valid on 2019.04.12