Aluprof DC 920 프로그래밍 매뉴얼 - 페이지 2

{카테고리_이름} Aluprof DC 920에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof DC 920 4 페이지.

3. OPERATING MODE CHANGE

Press "MODE" button. Mode

will channge.

Manual mode - without time control function,

Automatic mode - with time control function,

Random mode - with time control function with a random selected time within ± 15 minutes to the set automatic time.

4. ACTIVE CHANNEL SELECTION

Switch to automatic or random

mode.

5. SETTING OF THE CURRENT TIME

Switch to manual mode

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

PROGRAMMING MANUAL OF THE DC 920 TRANSMITTER

By reapitting procedure

will change mode between:

"Manual",

"Automatic",

"Random".

Select the chosen channel.

Press and hold "TIME"

button for 5 seconds. Hour digits

will flash.

Press and hold "TIME" button for 5

seconds till flashing of the icons on

LCD will stop and currently set time

will be displayed.

Press "P2" button, the digit

of the disabled channel will flash.

By pressing the "UP" or "DOWN"

buttons, settings of the

hour can by change.

Again press of the "P2" button

will switch off chosen

channel.

Press "TIME" buttons.

Minutes digits will flash.

We reserve the right to any technical change.

Valid on 2022.04.04