DL diode led 설치 매뉴얼 - 페이지 2
{카테고리_이름} DL diode led에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DL diode led 2 페이지. 12vdc; 24vdc
페이지 인쇄INSTALLATION CONT.
3
FASTEN WIRE TO SURFACE.
Place wire fastener around
wire and hammer into place.
4
CHOOSE OPTION (a) OR (b) FOR CUTTING
INSTRUCTIONS.
Applies to AVENUE 24™, FLUID VIEW®, VALENT®, VALENT®
a
HD, and ULTRA BLAZE™ tape lights.
Cut at the line indicated with scissors icon.
−
®
+
Applies only to BLAZE™ tape light:
b
DO NOT cut at scissors icon. Instead, cut tape light along outside
edge of LED chip closest to scissors icon so four contact/solder
points remain intact to tape light.
−
+
5
ATTACH TAPE LIGHT TO CLICKTIGHT.
−
+
−
+
−
+
−
+
6
TEST CONNECTION.
Prior to mounting, turn on power and test connection to
ensure system is operating properly. Turn off power again
before mounting.
PRO INSTALLATION GUIDE
CLICKTIGHT
®
−
®
+
−
−
−
+
+
+
−
®
+
−
®
+
Determine orientation of
tape light for correct polarity.
1
−
1
®
+
−
2
®
+
Insert strip under
2
metal contacts.
®
®
®
®
7
MOUNT TAPE LIGHT TO SURFACE.
Prep surface to remove dust and dirt. Adhere to a smooth,
finished, dry surface.
Utilize included Tape Light Fastener to secure tape to surface.
Fasten with small screwdriver.
DO NOT PLACE FASTENER ON LED CHIPS OR RESISTORS!
8
ADD TAPE-TO-TAPE CONNECTORS AND/OR
BENDING EXTENSIONS.
TAPE-TO-TAPE
−
−
CONNECTOR
+
+
BENDING EXTENSION
(2x TAPE-TO-WIRE
CONNECTORS)
TROUBLESHOOTING
Symptom
Common Cause
Fixture does not
• Incorrect wiring. Polarity of Low Voltage V+ and V- are
illuminate
• Circuit breaker is OFF or tripped.
• Incorrect voltage pairing of dimmer and fixture. 12 V
Fixture flickers
• Connection is not secure. Check connection at crimp,
randomly, may
shut off
Fixture will
• If tape light does not fit under CLICKTIGHT prongs due
not insert into
CLICKTIGHT
2 OF 2
−
®
+
reversed. Check connection at every CLICKTIGHT to
ensure polarity is not reversed.
dimmer models will not power a fixture with a higher
voltage rating.
at metal prongs of CLICKTIGHT and at any other
connections.
to tightness, gently slide a 1/8" flat head screwdriver
under prongs (shown below). Once both prongs are
loosened, proceed to slide tape light under prongs.
−
®
+
®
−
®
+
+
−
IG121815-3.0