DL SILENT +5500 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} DL SILENT +5500에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DL SILENT +5500 12 페이지.

Rinse each part with water, using a soft brush to remove the deposit.

Then assemble everything in the inverse order

Put the ring in place with the biggest teeth facing the pump and close it by pressing on the tab until you hear a "click". (Pic. L). Any damage to the o-rings,

even small, can seriously endanger the pump performance. In this case, it is best to replace them.

CLICK

BIG TEETH

BEHIND

IMPORTANT: The build-in circuit board of the pump has been programmed to provide 3 levels of protection:

Protection against rotor's blockage: In case of malfunction which causes the lock of the rotor (due to excessive dirt or other) or of operating without water,

the pump, after 20 attempts to start, followed by a short interval of time, and other 20 attempts will stop automatically. If this does not happen, the pump will

automatically go on standby, the electronic board will remain powered but the engine will shut down. In this case to restart the pump you need to remove

and re-insert the plug into the power outlet.

Dry running protection and thermal protection: motor's protection in case of functioning without water. The pump stops when it works without water, or if

there is a locked rotor. When the pump is taken out from the water, the motor stops.

ATTENTION: do not underestimate the power of the magnet. If you slightly loose the grip and the axis hits the rear bearing, the risk to damage the bearing

is very high. A damage axis and bearing causes high reparation costs. (Pic. M)

RIGHT SIDE

DL SILENT · 2400 · +5500 · +7000

INSTRUCTION MANUAL · EN