ARTRED AR-55 소유자 매뉴얼 - 페이지 8

{카테고리_이름} ARTRED AR-55에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARTRED AR-55 11 페이지. Scrubber-dryer

페이지 인쇄

Warning:

1. Move the machine to the place with good ventilation for charging.

explosion hazard. The battery releases hydrogen. Please be away from spark or

open fire. The battery cabin must be kept open when charging.

2. Stop and place the machine on the level ground and turn the key to the close

position.

3. Before charging, check the electrolyte level in each battery unit.

For safety: Please wear protective gloves and eye protectors when treating the

battery and battery wiring when repairing the machine. Avoid contacting the

battery liquid acid.

4. When charging, please open the side of the waste water tank to

facilitate ventilation.

5. Plug the AC (alternating current) power cord of the charger to the

power socket with sound grounding.

6. Plug the DC (direct current) power cord of the charger to the battery

charging socket behind the waste water tank.

Warning: f

ire or explosion hazard. The battery releases hydrogen. Please be

away from spark or open fire. The battery cabin must be kept open when

charging.

5. After the charging is completed, recheck the electrolyte level.

Machine Maintenance

Only by indeed following daily, weekly and monthly maintenance

procedure can the machine be kept in the optimum working state.

Warning:

Electric shock hazard. Please firstly disconnect the battery wring

before maintaining the machine.

Daily Maintenance (after each use)

1. Drain and clean the waste water tank

2. Dismantle and flush the floating filter screen in the waste water tank

3. Drain the clean water tank and flush the water tank with hot water of

no higher than 60℃ as required

4. Dismantle the scouring pad/brush for cleaning. If there is any

abrasion, overturn or replace the scouring pad

5. Wipe the squeegee adhesive tape. Place the squeegee component in the

rising position to avoid damage to adhesive tape.

6. Check the abrasion conditions of the scraper edge of the squeegee

adhesive tape. If there is any wear and tear, exchange two sides of the

adhesivetape.

7. Use multi-purpose detergent and wet cloth to wipe the machine. For safety:

please do not spray this machine with high pressure or flush this machine with

water pipe when cleaning the machine to avoid failure of electronic component.

8. Check the abrasion conditions of the skirt side of the brush head and

replace it if there is any wear and tear or damage.

9. Charge the battery. To prolong the life of the battery and ensure the

optimum efficiency of the machine, the battery must be charged after the use

time of the machine exceeds 30min.

ire or