Alutech Sun Shield EM3430L 사용 설명서 - 페이지 4
{카테고리_이름} Alutech Sun Shield EM3430L에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alutech Sun Shield EM3430L 13 페이지. Retractable awning
페이지 인쇄Do not install the awning when you find damage parts are that parts are missing.
Do not allow children to play in the working area during assembly
This product is only suitable for installation in the cement wall or ceiling.
Nobody is allowed to change the products' design and structure without the permission
of manufacture or authorized deputy.
Please make sure that your hands are clean at the time of the assembly; otherwise you
may soil the awning fabric and frame.
The operation in frosty conditions may damage the awning.
The operation in snowy conditions may damage the awning.
In case of rain Retract the awning if pitch angle is less than 14°.
Nobody is allowed to climb onto the awning; hanging anything on the awning is
Sheeting was used to protect the paint. This must be removed afterwards.
When extended, various forces, including wind and rain, will affect an awning. These
sometimes substantial forces must be absorbed by the awning and transferred to the
assembled structure via its mounting brackets. Under extreme loads, excessive
attractive force can be exerted on the anchor bolts. Therefore, before starting assembly,
check the load-bearing capacity of the mounting base and if necessary take
corresponding measures to ensure stable installation of the brackets. If the mounting
base is unstable, you may wish to consult a specialist in yourvicinity.
The awnings are intended as a protection against the sun only. It is not to be used
during periods of strong wind, rain, hail, or snow. In case of such conditions, retract the
awning immediately.
Preparation
Carefully remove the awning from the box and remove the styrofoam protectors from the awning.
Remove the plastic bags and plastic guards from the awning and carefully place the awning aside
to avoid having it damaged by scratches or otherwise damaged or soiled during assembly. Check
the number of parts in the packaging whether the packing list requirements, the quality of parts
availability issues, if questions, please contact the supplier.
Be aware the sudden extension may occur during unpacking.
Tools needed for assembly:
Drill
Masonry drill bit, 14 mmLevelindicator
Wrench13mm、17mmand19mm
Stepladder
Tape measure
Chalk or marker pen
Wooden hammer
4