ALUZ A1-ZIBI-STN-DWH 매뉴얼
{카테고리_이름} ALUZ A1-ZIBI-STN-DWH에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALUZ A1-ZIBI-STN-DWH 13 페이지.
페이지 인쇄Mounting Clip
(A1-ZIBI-STN-MC)
Aluminum Extrusion
(A1-ZIBI-STN)
Dynamic White LED
with Individual Optics
(Included)
Tempered Clear Glass Lens
GENERAL FEATURES
Applications
Wall Washing Lighting
Lens
Tempered Clear Glass Lens
Optics & Asymmetric
10° - 60° or Asymmetric Optics
Length
Built to Order (2', 3', or 4' Increments)
Construction
Aluminum Extrusion
Weight
5.6 lbs (2'), 7.9 lbs (3'), 11.2 lbs (4')
Mounting
Mounting Clips (Sold Separately)
Dry, Wet, or IP67 Location
UL1598, CSA C22.2#250.0
Listing
UL8750, CSA250
UL2108, 67.1.9, 60.4, CSA C22.2 #9
Driver
Integral
Operating / Startup: -20° to 48°C (-4° to 120°F)
Temperature Ratings
Storage: -40° to 76°C (-40° to 170°F)
Installation Link
ELECTRICAL
Dimming
0-10V, DMX, DALI (Type 6)
Maximum Run
100' (1.5W, 2W, 3W), 80' (4W), 64' (5W), 53' (6W), 45' (7W)
(Line Voltage
Integral Driver)
Luminaire Voltage
120V - 277V (UNV)
COMPATIBLE CONTROL INTERFACES
• 0-10V
• Distech Controls
• DALI2
• Legrand
• DMX
• Wattstopper
• Acuity Controls / nLight
• Pass & Seymour
• eldoLED
• Leviton
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
Optional Louver
(A1-ZIBI-STN-LVR)
(A1-ZIBI-STN-CGL)
• Crestron / Cresnet /
SolarSync
• Eaton
• Tridonic / Bluetooth
866.ALUZ.LTG | 714.535.7900
READ ENTIRE GUIDE BEFORE STARTING INSTALLATION
Important Notice: Verify correct luminaire was received with correct
color temperature, voltage, and wattage before cutting or installing.
ALUZ will not be responsible if incorrect luminaire is installed.
END VIEWS / DIMENSIONS
2.52"
Wet Location
Power Lead
(Included)
2.69"
No Accessories
(A1-ZIBI-STN)
PRODUCT INFORMATION
• Lighting for wall washing, cove, edge, undercabinet, accent, displays
• Line Voltage (Integral Driver)
• Dynamic White LEDs
• Available in 3 Watts up to 7 Watts Per Foot
• Product is shipped in 1', 2', 3', and 4' luminaires
• Available for outdoor rated installations
ELECTRICAL REQUIREMENTS
• Line Voltage luminaires do not require a remote driver.
• Maximum load per line voltage fi xture is 320 watts per circuit.
INSTALLATION TOOLS REQUIRED
• Electric Hammer Drill
• 14.4 to 28 Volt Cordless Drill
• Phillips Bits
• Utility Knife
• Electrical Cord
• Marker
• Wire Stripper
2.60"
3.70"
3.70"
With Louver
With Reflector
(A1-ZIBI-STN-LVR)
(A1-ZIBI-STN-RE1)
• Long Nose Pliers
• Drill Bits - Concrete or Wood
• Electrical Three Ways
• Safety Glasses
• Measuring Tape
• Laser Line or Chalk Line
Installation Instructions
9 / 11 / 2023 / Rev 4
Page 1 of 13
Overview
2.60"