DLO TransDock 사용자 설명서 - 페이지 6
{카테고리_이름} DLO TransDock에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DLO TransDock 13 페이지. Fm transmitter for ipod
DLO TransDock에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)
페이지 인쇄Finding Empty Radio Frequencies Using IntelliTune
To find an empty frequency using IntelliTune:
1. Press the center button
on your TransDock. This will activate the Intelli-
Tune search. While searching, the word "IntelliTune Searching" will appear
on your TransDock' display.
2. Once IntelliTune finds an empty frequency, it will display "TUNE TO XXX.X."
Tune your FM radio to the corresponding station and begin enjoying your
iPod music over your car stereo.
Manually Finding Empty Radio Frequencies
Your TransDock also allows you to manually tune the transmitter to desired FM
frequencies. Simply push the right button to tune to higher stations and push
the left button to tune to lower stations.
Tips for manually finding an empty station:
• Be sure to search the entire spectrum of FM frequencies.
• When using scan/seek on your car's radio, if your tuner stops on 101 and
then jumps to 103, look in the 102 frequencies for empty stations.
10 |
DLO TRANSDOCK USER MANUAL
• Try tuning to a strong station, then backing down two frequencies – for
example 103.5 to 103.1. You can often find empty frequencies this way.
Note: If that frequency is taken, scan to the next station and try again.
Using Your Detachable 12V Power Socket
The detachable 12V Power Socket allows you to
power other devices while enjoying your TransDock.
To install, locate the 5.5mm port on the back of the
TransDock and insert the 5.5mm jack. This will
activate the DC 12V Power Socket.
IMPORTANT:
Do not insert anything other than an
appropriate plug that fits the socket, or allow any
liquid to get into the socket. Doing so may cause
electrical failure, electric shock, or a short circuit.
The total combined current for the 12V DC socket
should not exceed 10 amps. This accessory outlet
should be used for accessories only; do not use a
lighter element in this outlet.
| 11