Alva GHP16 사용 설명서 - 페이지 12
{카테고리_이름} Alva GHP16에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alva GHP16 17 페이지.
페이지 인쇄
The leak test must be carried out in a well-ventilated area, free
from any flames or other sources of ignition.
Connection
in assembly
Foamy
bubbles
indicate a
leak
Connections to be leak tested
Regulator into cylinder
Hose to regulator
Hose to appliance
Fig.J
USING YOUR HEATER
LEAK TEST
•
With the cylinder connected to
the heater. Open the cylinder
valve.
•
Brush the connections (heater
to cylinder) with a solution of
equal parts soap and water
(make sure it's foamy).
•
A stream of bubbles forming in-
dicates a gas leak. (See Fig.J)
•
If bubbles appear, turn the
cylinder valve OFF (clockwise)
and disconnect the heater from
the gas cylinder.
•
Tighten the connection and
retry the leak test.
•
If you are unsure or if you
cannot tighten the connection,
place the cylinder outside in a
cool, well-ventilated area and
contact Alva on 086 100 ALVA
(2582).
•
A leak between the heater and
cylinder can lead to a high
pressure fire, which is very
dangerous and can result in
extensive injury or even death.
Fig.K
9
How to do
a leak test
http://www.
youtube.com
/watch?v=8L
pZ1B0m23Y
&feature=plcp
FOR YOUR SAFETY
IF YOU SMELL GAS
•
Turn off the gas
supply at the
bottle.
•
Extinguish all
naked flames.
DO NOT operate
any electrical
appliances.
•
Ventilate the
area.
•
Check for leaks
(see LEAK TEST)
•
If odour per-
sists, contact
your dealer or
local gas supplier
immediately.
Before proceeding to
ignite the heater, make
sure you understand
the "IMPORTANT
SAFETY
INFORMATION"
section of this manual.