3M 9700 사용 설명서 - 페이지 8

{카테고리_이름} 3M 9700에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 9700 15 페이지. Operating instructions

Lamp Replacement

Use the proper lamp type for your projector.

FXL 410W 82V

EVD 400W 36V

1. Push power switch to "Off" and unplug projector.

2. Release cover latch and lift up stage cover.

Lamp and adjacent metal parts are hot. Allow lamp

to cool before replacing.

Rotate the colour tuning dial to eliminate the

yellow/orange to brown or blue corners projected on the

screen.

1. Rotate dial to the left to remove blue corners.

2. Rotate dial to the right to remove yellow corners.

3M 9700 Operator's Guide

3. After lamp has cooled, remove and discard.

a. FXL Lamps: Pull back on lamp ejection lever

to release. Pull lamp out.

b. EVD Lamps: Lift retaining bracket to open

condenser lens frame. Pull lamp out.

FXL

4. Push new lamp fully and squarely into socket.

For EVD lamp, do not touch bulb glass with

fingers. Close condenser lens frame and secure

with bracket.

5. Close stage cover and plug in power cord.

There are two unswitched AC power outlets, for

powering accessories, connected to a 5 amp circuit

breaker.

Caution

Do not overload outlets with accessories that

exceed a total of 5 amps.

To Reset the Circuit Breaker:

1. Unplug accessories and lift stage cover to access

circuit breaker.

2. Push down on circuit breaker lever to reset.

EVD