DLP 30HPRA-E-410 소유자 매뉴얼 - 페이지 8
{카테고리_이름} DLP 30HPRA-E-410에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DLP 30HPRA-E-410 17 페이지.
페이지 인쇄FB F FB
The DPL Swimming Pool Heat Pump is designed for easy operation. The side panel contains a digital temperature
control readout. The Heat Pump is set to reach and then maintain the selected pool water temperature, as long as the pool
pump is running.
To start the unit:
> Press the
button. In normal operating mode, the display indicates the water temperature in centigrade degrees.
To stop the heat pump, press the
button again.
To adjust the temperature to the desired value:
> Press the
button until the red pilot light
> To adjust the water temperature, press the
The available temperature range is between 18 °C and 35 °C.
> To return to normal operating mode, press the
The
pilot light turns on whenever the heat pump is in operation, which means that the ventilator(s) and the compressor
are functioning in order to heat the pool.
All models use a 5-minute time delay to prevent repeated tripping of the compressor's overload protection mechanism, which is
caused by attempting startup before system pressures are equalized. Any interruption will result in a 5-minute time delay.
The
pilot light will blink during this 5-minute time delay.
To display the temperature in farenheit (°F) or celcius (°C), Press the
for 3 seconds to select the desired temperature scale.
A:
A
E
B:
pilot light
C: Digital display
F
D: Button to set temperature at desired value
B
C
E: Start/stop button
D
F: Temperature adjustment buttons
Warning:
Prior to starting the heat pump, you must ensure that:
> There is electricity supplied to the heat pump.
> The filter pump is operating with a minimum water circulation of 6 m
If these two conditions are not met, the heat pump will not start. In such a case, the digital display thermometer will be un-
usable.
TIP:
Setting the thermostat to its highest setting will not heat the water faster than setting it at the desired temperature.
//, )%3 4-0 $7
turns on.
or
buttons until the targeted temperature is displayed.
button again, for at least 5 seconds.
and
buttons simultaneously
pilot light
/h.
3
EBBB EF EFBF EF B CCB EF DB
C/-&% () '%,/1 ),7'31+'% 0%1% 0+2'+.%2 $78
80HPRA-E-410 - 100HPRA-E-410