DLP 50HPRA-E-410 소유자 매뉴얼 - 페이지 9

{카테고리_이름} DLP 50HPRA-E-410에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DLP 50HPRA-E-410 17 페이지.

EBBB EF EFBF EF B CCB EF DB

50HPRA-E-410

C/-&% () '%,/1 ),7'31+'% 0%1% 0+2'+.%2 $77

FFB B FB FB

> Make sure that the electrical breaker for the pool heat pump is in the OFF position.

> Ensure the water lines and the heat pump are reconnected and/or drain valves are closed.

> Clean the pool filter and make sure the water is flowing adequately through the pool return line (5.1 m

> Complete your normal preparation and/or cleaning of the pool for the start of the season.

> Switch ON the breaker for the electrical supply to the heat pump.

> Then you need only start the unit and adjust the temperature to the desired value.

> Switch OFF the breaker for the electrical supply to the heat pump.

> You must empty the unit of all water. Simply disconnect the WATER INLET and WATER OUTLET lines by unscrewing the

two union fittings on the front of the unit. To completely remove the water from the heat exchanger, you must remove the

drain cap (WINTERIZING DRAIN) that is located on the side of the unit. You must then let the water flow out until the unit is

completely emptied. (See the illustration below.)

It is recommended to cover the heat pump with a protective cover that is available from your dealer.

A: WATER INLET

B: WATER OUTLET

C: CONDENSATION WATER DRAIN PIPE

D: WINTERIZING DRAIN (with plastic caps)

/h to 15 m

/h).

//, )%3 4-0 $8