3M Digital Projector X15 제품 안전 매뉴얼 - 페이지 8

{카테고리_이름} 3M Digital Projector X15에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Digital Projector X15 13 페이지.
3M Digital Projector X15에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

Replacing Lamp

The glass lamp used in this projector contains small amounts of mercury and operates at

high pressure and at high temperature and may unexpectedly shatter. Each lamp has a

different lifetime and can fail in different ways, including a rupture with a loud bang or

simply burn out. In the event of a lamp rupture, be sure to follow the instructions.

•

To reduce the risk associated with exposure to hazardous voltage:

Disconnect power cord when the projector is not in use, during lamp replacement,

and while cleaning.

Do not remove any screws other than those speciﬁed in the lamp replacement instructions.

Do not attempt to service the projector - there are no user serviceable parts, other

than the lamp cartridge, inside the projector. Contact a 3M authorized service

provider for service.

•

To reduce the risk associated with hot surface of lamp cartridge:

Unplug the projector from the electrical outlet and allow the lamp to cool for 45

minutes before replacing the lamp.

•

To reduce the risk associated with a ruptured lamp:

Always handle the fragile lamp module with care.

Remove the projector from the ceiling or wall mount before replacing the lamp. In

the case of a lamp rupture, small glass particles could fall out when the lamp door

is opened or the projector is tilted.

Use care when replacing the lamp module in the event of a lamp rupture - small

glass particles and small amounts of mercury may be present.

Ventilate the area where the lamp rupture occurred.

Wear safety goggles and gloves when cleaning up ruptured lamp debris.

Carefully collect the ruptured lamp debris in a closed container and dispose of the container

and the expired lamp module in accordance with federal, state, and local regulations.

Wash your hands thoroughly after handling ruptured lamp debris.

Replace the lamp module when the lamp replacement message appears.

Never replace the lamp module with a previously used lamp module.

•

To reduce the risk associated with environmental contamination due to

mercury in the projection lamp:

Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.

•

To reduce the risk associated with explosion, and/or chemicals from a leaking battery:

Use only with battery type AA or equivalent.

Orient the battery's plus (+) and minus (-) terminals of the batteries according to

the markings found on the remote control.

Do not leave the battery in the remote for an extended period of time.

Do not heat, disassemble, short, recharge, or expose to ﬁre or high temperature

Do not carry batteries loose in your pocket or purse.

Avoid eye and skin contact in the event that battery would leak

Do not mix used and new batteries.

•

To reduce the risk associated with intense visible light:

Avoid looking directly into the projector lens while the lamp is on.

Important Note:

If the lamp breaks soon after the ﬁrst time it is used, it is possible that there are electrical problems

elsewhere besides the lamp. If this happens, contact your local dealer or a service representative.

WARNING

CAUTION

3M™ Digital Projector S15/X15 Product Safety Guide