AKO HC 210 TSD 사용 설명서 - 페이지 4

{카테고리_이름} AKO HC 210 TSD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AKO HC 210 TSD 16 페이지.

페이지 인쇄

Operating Instructions

Fan Heater

1. Important Information

Keep these instructions in a safe place and pass them on to

possible future owners.

• Use device for room heating within enclosed rooms only.

• Repairs and corrective measures may only be carried out by

skilled technicians.

• Disconnect the power supply in the event of fault (pull out

the device plug or switch off the fuse).

• Do not use this device next to the bathtub, shower,

washbasin or swimming pool.

• The device carries the symbol shown on the right,

which indicates that the heating device must under

no circumstances be covered with any objects.

• Children or persons who are not capable of operating the

device safely must not operate the heating device. Ensure

that children do not play with the device.

• Caution! Potential dangers can arise when the device

switches on automatically, e.g. devices which have been

covered or blocked by objects since they were last used can

cause fire.

• Do not operate the heating device in rooms where highly

flammable substances are used (e.g. solvents, etc.).

• Do not lay the connecting cable across the device.

2. Technical Device Description

Heat output: 2000 W

Degree of protection: IP21

Connection voltage:

1/N~, 230-240 V, 50 Hz

Dimensions in mm:

(W x H x D) 235 x 569 x 235

3. Installation

Do not cover the heating device with any objects; fire hazard!

The fan heater may only be used as shown, i.e. on a horizontal,

even surface. Using it on deep pile carpets is not permitted.

Please use caution when installing it in front of flammable

objects. The power plug must always be accessible.

Observe the minimum clearances.

4. Electrical Connection

The voltage information on the type plate must match the local

mains voltage.

The indicator lamp is lit, when the device is plugged in.

When the power cord of this device is damaged, it must be

replaced by a qualified person, in order to avoid risks.

HC 210 TSD

5. Operation

Start the heater by pressing the on/off button.

5.1 Setting the operating mode

Pressing the "Operating mode" button allows you to choose

between the following functions.

5.1.1 Automatic mode

The device heats at the high heating level. You can set the

temperature you want using the +/- buttons. The device

switches off automatically when the set temperature is reached

and back on again when the temperature falls below the value

set.

5.1.2 Fan mode

Fan on without heating.

5.1.3 Heating mode - low heating level

The device heats at 50% of the maximum heat output. The

temperature cannot be set.

5.1.4 Heating mode - high heating level

The device heats at the maximum heat output. The

temperature cannot be set. All of the valid settings made using

the buttons are confirmed by an acoustic signal. The settings

made last are saved as long as the device is plugged in.

5.2 Rotating mode

Pressing the "OSC" button switches rotating mode on and off.

The heater rotates by a total of 90° to the left an d right in fan or

heating mode.

5.3 Timer

Pressing the "Timer" (remaining time) button limits the heater's

operating time. If, for instance, "1HR" is set, the device

switches off after one hour has elapsed. It is only possible to

set full hours up to a maximum of 8 hours of remaining time.

Warning!

Depending on the size of the room, heat requirement and

thermostat setting, rooms may overheat if the heating is not

controlled. This can be dangerous for people who are not able

to leave the room as it gets too hot.