3M Digital Projector X30 제품 보증 및 안전 매뉴얼 - 페이지 13

{카테고리_이름} 3M Digital Projector X30에 대한 제품 보증 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Digital Projector X30 19 페이지. Technical
3M Digital Projector X30에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 운영자 매뉴얼 (20 페이지)

페이지 인쇄

Replacing Lamp

The glass lamp used in this projector contains small amounts of mercury and operates at

high pressure and at high temperature and may unexpectedly shatter. Each lamp has a

different lifetime and can fail in different ways, including a rupture with a loud bang or

simply burn out. In the event of a lamp rupture, be sure to follow the instructions.

Disconnect power cord when the projector is not in use, during lamp replacement,

and while cleaning.

Do not attempt to service the projector - there are no user serviceable parts, other

than the lamp cartridge, inside the projector. Contact a 3M authorized service

provider for service.

Unplug the projector from the electrical outlet and allow the lamp to cool for 45

minutes before replacing the lamp.

Always handle the fragile lamp module with care.

Remove the projector from the ceiling or wall mount before replacing the lamp. In

the case of a lamp rupture, small glass particles could fall out when the lamp door

is opened or the projector is tilted.

Use care when replacing the lamp module in the event of a lamp rupture - small

glass particles and small amounts of mercury may be present.

Ventilate the area where the lamp rupture occurred.

Wear safety goggles and gloves when cleaning up ruptured lamp debris.

Carefully collect the ruptured lamp debris in a closed container and dispose of

the container and the expired lamp module in accordance with federal, state, and

local regulations.

Wash your hands thoroughly after handling ruptured lamp debris.

Replace the lamp module when the lamp replacement message appears.

Never replace the lamp module with a previously used lamp module.

mercury in the projection lamp:

Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.

The lamp in this product contains mercury. Dispose of projection lamp in a manner

that is consistent with your local hazardous waste regulations for mercury.

For recycling and disposal information, contact your respective governmental

agencies.

In U.S., contact 1-800-328-1371 (3M US) or the Electronic Industries Alliance at

www.lamprecycle.org

In Canada, contact 1-800-364-3577 (3M Canada)

Important Note:

elsewhere besides the lamp. If this happens, contact your local dealer or a service representative.

WARNING

3M™ Digital Projector X30 Product Warranty and Safety Guide