3M Digital Projector X30N 제품 보증 및 안전 매뉴얼 - 페이지 9
{카테고리_이름} 3M Digital Projector X30N에 대한 제품 보증 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Digital Projector X30N 19 페이지.
3M Digital Projector X30N에 대해서도 마찬가지입니다: 사양 시트 (2 페이지)
페이지 인쇄
3M™ Digital Projector X30N/X35N
•
To reduce the risk associated with environmental contamination:
-
Dispose of exhausted batteries in accordance with applicable federal, state, and
local regulations.
•
To reduce the risk associated with explosion, and/or chemicals from a leaking
batteries:
-
Use only with battery type AA (HITACHI MAXELL Part No.LR6 or R6P).
-
Orient the battery's plus (+) and minus (-) terminals of the batteries according to
the markings found on the remote control or internal clock battery case.
-
Do not leave the battery in the remote for an extended period of time.
-
Do not heat, disassemble, short, recharge, or expose to fire or high temperature.
-
Do not carry batteries loose in your pocket or purse.
-
Avoid eye and skin contact in the event that battery would leak.
-
Do not mix used and new batteries.
-
Obey the local laws on disposing the battery.
•
To reduce the risk associated with the impact of a falling projector:
-
Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling
mounting is desired.
-
Installation of the 3M™ wall/ceiling kit must only be performed by qualified personnel.
-
Adhere strictly to the proper installation procedure as outlined in the installation
instructions when installing the 3M™ wall/ceiling kit.
-
Always operate the unit on a flat, sturdy, and horizontal surface.
•
To reduce the risk associated with intense visible light:
-
Avoid looking directly into the projector lens while the lamp is on.
•
To reduce the risk associated with tripping and/or impact:
-
Position the power cord and data cable so that they cannot be tripped over.
•
For safety, do not connect the LAN port to any network that might have
excessive voltage.
© 3M 2009. All rights reserved.
CAUTION
Product Warranty and Safety Guide
9