DLS CC-2 설치 및 운영 방법 - 페이지 9

{카테고리_이름} DLS CC-2에 대한 설치 및 운영 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. DLS CC-2 12 페이지. Dls amplifier
DLS CC-2에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

Speaker wiring CC-4 / CC-44

3. Two subwoofers or stereo speakers brid-

ged to CC-4 / CC-44.

4 ohm

One 4 ohm subwoofer or speaker connected

to channels 1 / 2 and one 4 ohm subwoofer or

speaker connected to channels 3 / 4.

4 ohm

Filter settings front channels CH 1 / 2

Filter settings rear channels CH 3 / 4

The low pass filter is

mostly used for sub-

woofers. It will allow low

frequencies only and

blocks higher frequen-

cies. A typical setting is

60 – 70 Hz.

Set the push button to ON and the HPF / LPF

button to LPF (button IN) to activate the filter.

When the CC-4 is used for bridging a stereo

speaker pair set use only the HPF filter. Set the

push button to ON and the HPF / LPF button to

HPF (button OUT) to activate the filter, or OFF if

you want to run the amplifier in full range mode

without limiting the frequency range.

Adjust with the HPF control after your own taste,

a normal setting is 50-70 Hz.

For power wiring, see page 3-4

For high or low level input wiring, see page 4

CC-4 / CC-44