DLS CC-500 사용자 설명서 - 페이지 7

{카테고리_이름} DLS CC-500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DLS CC-500 12 페이지. Dls amplifier
DLS CC-500에 대해서도 마찬가지입니다: 설치 및 운영 방법 (12 페이지)

Speaker wiring CC-2

Two fullrange speakers to channel 1 / 2

NOTE!

Minimum amplifier load is 2 ohm in stereo mode,

lower impedances may damage the amplifier.

The speakers can be coaxial speakers or 2/3-way

kits.

Filter settings CH 1/2 for 2-channel stereo use

The high pass filter

blocks very low fre-

quencies from reach-

i n g t h e s p e a k e r s ,

mostly used to protect

small speakers from

deep bass.

Set the push button to ON and the HPF / LPF

button to HPF (button OUT) to activate the filter,

or OFF if you want to run the amplifier in full range

mode without limiting the frequency range.

Adjust with the HPF control after your own taste,

a normal setting is 50 - 70 Hz.

One 4 ohm subwoofer bridged

NOTE!

Minimum speaker impedance in bridged connec-

tion is 4 ohm, this connection gives a 2 ohm load

with a 4 ohm subwoofer (the load is halved when

connected in bridge mode).

Do NOT use subwoofers with lower impedance

than 4 ohm. Connect speaker + to CH1+ and

speaker - to CH2

Filter settings CH 1/2 for subwoofer use

The low pass filter is

mostly used for sub-

woofers. It will allow low

frequencies only and

blocks higher frequen-

cies. A typical setting is

60 – 70 Hz.

Set the push button to ON and the HPF / LPF but-

ton to LPF (button IN) to activate the filter, or OFF

if you want to run the amplifier in full range mode

without limiting the frequency range.

For power wiring, see page 3-4

For high or low level input wiring, see page 4

CC-2