DLS 235-522-210 사용자 설명서 - 페이지 9
{카테고리_이름} DLS 235-522-210에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DLS 235-522-210 11 페이지.
페이지 인쇄
FlexxPump 500 DLS
Continuation sheet
7.
Operation and settings
7.1
General information
What you should know about operating and setting the FlexxPump 500 DLS:
For operation, the FlexxPump 500 DLS must be integrated into a control system
(PLC) and must be commanded and controlled via the PLC. The FlexxPump 500 DLS
delivers one or more strokes (one stroke = 0.15 cm³) depending on the signals of the
external control (PLC). Depending on the internal status of the FlexxPump 500 DLS
(e.g. cartridge empty), different output signals are issued by the FlexxPump 500 DLS.
If you have any questions about your application and the correct settings for Flexx-
Pump 500 DLS, please contact the manufacturer (chapter I.II).
Make sure that your PLC program is correct for your application and that the lubricati-
on point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate the FlexxPump 500 DLS.
If this is not the case, change your PLC program accordingly.
To use the FlexxPump 500 DLS, it first has to be properly mounted and installed. The
installation is very simple and described in detail in chapter 6.2.
If you order a special version of the FlexxPump 500 DLS from the factory, the infor-
mation on the supplement sheet is decisive for you!
Revision: 0
D L S
SCHMIERSYSTEME
D I R E C T
L U B R I C A T I O N
S Y S T E M S
EN-
09