10 Bar 220ex 사용자 설명서 - 페이지 6

{카테고리_이름} 10 Bar 220ex에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10 Bar 220ex 9 페이지. Camera housing

(Fig.

(Fig. 8)

Replace the lid, remember to ensure the pressure release plug is pulled all the way out while

closing, otherwise the air cannot escape. Squeeze the lid closed all the way, you will hear the hiss of air

being expelled.

(Fig. 9)

After replacing the lid, make a final visual inspection of the main O-ring for contamination (Fig. 9)

Note: If the O-ring is in good contact, a thin black line, about 0.5-1mm in width should be

visible, where the O-ring is in contact with the lid. Follow this line all the way round the

edge of the seal, as a final check that the seal is good.

The housing is now ready for the dive.

Important !!!

Before diving, make sure the pressure release plug is pushed

back inside and then screwed home, do not over tighten this plug (finger

tight only).