10 Bar Underwater Housings 5 D Mark II 사용자 설명서 - 페이지 6

{카테고리_이름} 10 Bar Underwater Housings 5 D Mark II에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10 Bar Underwater Housings 5 D Mark II 10 페이지.

4.5 Mounting the camera in the housing:

Remove the lens cap and wrist strap.

Attach the plastic slide tray to the camera's tripod mounting fixture with a screwdriver or the end of

the universal tool supplied. Take care not to excessively tighten the

screw. Slide the camera into the body along the guide rail. Make sure the camera body reach the

limit and test the function of the on/of button on the body of the housing. Slide the hot shoe plug into

the hot shoe.

Note: If you find that the buttons do not align properly with the controls, please check

again that the camera is properly seated to the limit of the guide rail.

Slide the camera into the body along the rubber packing. Make sure the camera body reach the

limit and test the function of the On/Off button on ths body of the housing.

Align the bulkhead cable as shown and check the cable is not jammed under any button or over the

o-ring. Slide the hot shoe plug into the hot shoe