ACP RiderPro 제품 및 설치 설명서 - 페이지 11
{카테고리_이름} ACP RiderPro에 대한 제품 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACP RiderPro 17 페이지. Motorcycle protection for acp sentry barrier tl-4 thriebeam system
페이지 인쇄RiderPro Installation Check List
Client: __________________________________________________________________
Location: __________________________________________________________________
Installed by: __________________________________________________________________
Inspected by: __________________________________________________________________
Date: __________________________________________________________________
Signature: __________________________________________________________________
The RiderPro has been installed in accordance with proprietor or state road agency
❑
specifications.
The RiderPro mounting brackets are positioned such that they are in direct contact with the
❑
guardrail post and at each guardrail post.
The RiderPro mounting brackets have been connected to the Sentry Post with the
❑
M10x25 hardware with the appropriate torque apply.
The RiderPro beams are secured to each mounting bracket with a M16 x 35mm bolt, standard
❑
nut and round washer.
The RiderPro beams are spliced with four M16 x 35 mm bolts, standard nuts and round
❑
washers.
❑
The RiderPro beams are lapped with the flow of traffic.
❑
The RiderPro system does not extend into the w-beam guardrail terminal section.
❑
The End terminal of the RiderPro is correctly installed at both ends of the length
❑
The ground clearance is correct along all the length of the RiderPro
❑
All bolts are tightened.
❑
The RiderPro system follows an even alignment with the upper thriebeam guardrail
❑
The RaiderPro ground clearance is respected
Ref: IM 031 Rev 00
Date: 15/07/2021
Page 11/17
Property of
Margaritelli Ferroviaria S.p.A.
06135 Ponte San Giovanni - Italy