aion CHROMA 매뉴얼 - 페이지 6

{카테고리_이름} aion CHROMA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion CHROMA 11 페이지. Based on boss sp-1 spectrum

aion CHROMA 매뉴얼
BUILD NOTES, CONT.
Setting the gain trimmer
According to the SP-1 service manual, the Gain trimmer should be set as follows:
Test signal: 5KHz +/- 10% sine, -20dBm, set SPECTRUM, BALANCE at max (FCW), adjust trimmer
pot 1K for 2.5dBm output at peaking freq. (5KHz +/-10%)
Follow the process if you want, but it's definitely overkill and an effect this simple does not need that
kind of precision. We couldn't hear much difference across the whole sweep of the trimmer, but it would
be most noticeable at full clockwise (wet) on the Balance control. You might be able to make its impact
more pronounced by raising the value of R7.
IC selection
The original SP-1 used the Raytheon RC3403A "ground-sensing" quad op-amp. Raytheon hasn't
manufactured analog components in several decades, and originals are scarce today—but fortunately
the New Japan Radio NJM3403A is an exact substitute and still in production.
CHROMA PARAMETRIC BOOST
6