aion DYNAMO 매뉴얼 - 페이지 7
{카테고리_이름} aion DYNAMO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion DYNAMO 10 페이지.
DRILL TEMPLATE
Cut out this drill template, fold the edges and tape it to the enclosure. Before drilling, it's recommended
to first use a center punch for each of the holes to help guide the drill bit.
Ensure that this template is printed at 100% or "Actual Size". You can double-check this by measuring
the scale on the printed page.
Top jack layout assumes the use of closed-frame jacks like the
open-frame jacks, please refer to the Open-Frame Jack Drill Template for the top side.
LED hole drill size assumes the use of a
size accordingly if using something different, such as a 3mm bezel, a plastic bezel, or just a plain LED.
INCH
0
1
CM
0
1
2
DYNAMO REACTIVE DISTORTION
5mm LED
bezel, available from several parts suppliers. Adjust
125B
0.625"
0.625"
ø3/8"
ø1/2"
OUT
DC
TONE
BASS
x: 0, y: +1.29
ø1/4"
x: -0.65, y: +1.71
ø9/32"
LEVEL
x: 0, y: +0.83
ø1/4"
MODE
x: -0.65, y: +0.41
ø9/32"
CENTER (0,0)
LED
FOOTSWITCH
x: -0.775, y: -1.775
x: 0, y: -1.775
ø5/16"
ø15/32"
Switchcraft
111X. If you'd rather use
ø3/8"
IN
DRIVE
x: 0.65, y: +1.71
ø9/32"
GAIN
x: 0.65, y: +0.41
ø9/32"
7