aion Nimbus 매뉴얼 - 페이지 2
{카테고리_이름} aion Nimbus에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion Nimbus 9 페이지. Dynamic overdrive
페이지 인쇄
TABLE OF CONTENTS
1 Project Overview
2 Introduction & Usage
INTRODUCTION
The Nimbus Dynamic Overdrive is an adaptation of the Maxon OD-820 Overdrive Pro, first released in
2004 as part of Maxon's Vintage Series alongside the AD-999 Analog Delay, DS-830 Distortion Master,
PH-350 Rotary Phaser, and a few others.
Despite the name, the Vintage Series were not reissues of vintage circuits. The pedals in the series were
released in the same big-box enclosure style they used in the 1970s, but featuring all-new designs,
vintage-inspired with modern improvements.
With its bipolar +/-9V charge pump and dual-pot "gain/blend" control, the Maxon OD-820 Overdrive
Pro actually shares a lot of concepts with the Klon Centaur. They are often compared with one another
in sound, but it is by no means a clone. The OD-820 is actually a little closer to a Tube Screamer with
regard to its clipping diodes and tone control. (Check out
comparing the OD-820 with the Klon Centaur.)
The OD-820 is the same circuit as the later VOP-9 Vintage Overdrive Pro. The OD-820 has a larger
enclosure that matches the other Vintage Series effects while the VOP-9 is housed in the smaller
standard Ibanez 9-series enclosure.
USAGE
The Nimbus has the same control layout as most overdrive or distortion effects:
• Drive is a dual-gang potentiometer that simultaneously controls the amount of gain in the op-amp
feedback diode clipping stage and blends between clean and drive, similar to the Klon Centaur.
• Tone controls the treble response of the effect. The center point (12:00) is flat. When turned to the
left, it cuts treble, and when turned to the right, it boosts treble.
• Volume controls the overall output of the effect.
NIMBUS DYNAMIC OVERDRIVE
9 Licensing
this Legendary Tones article from 2004
2