ACP MXP5203 지침서 - 페이지 5

{카테고리_이름} ACP MXP5203에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACP MXP5203 6 페이지.

Install new switch cover onto secondary interlock switch using existing hex head

screws. (New switch cover is made of thicker material)

Note: Make sure to align holes and interlock switch top with cover and tighten switch

cover to previous switch setting - see figure 9 and figure 10.

Figure 9

g) Remove cavity to base mounting clips or rear cavity support brackets LH & RH from

base of oven by accessing mounting screw thru air inlet on side of base - see figure 11

or figure 12.

Mounting Clip

Figure 11

6. Turn Oven on Top

a) Rotate oven on its switch side being careful not to damage any loose components.

Rotate oven again so the oven base is on the top.

7. Base Removal

a) Remove 4 screws from front of the base - see figure 14.

b) Remove 4 frame mounting screws from rear of oven.

c) Slide hinges away from base and lift base from oven.

ACP, Inc.

225 – 49TH Avenue Drive SW

Cedar Rapids, IA 52404

Figure 10

Rear Cavity Support

Bracket

Figure 12

PART #: 16200051

REV. 1

DATE: 9-6-12

Page 5 OF 6