aion PEPPERMILL 매뉴얼 - 페이지 2

{카테고리_이름} aion PEPPERMILL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion PEPPERMILL 9 페이지.

1 Project Overview

2 Introduction & Usage

INTRODUCTION

The Runoffgroove Peppermill is a simple circuit designed to showcase the tube-like clipping

characteristics of the J201. It's a very minimalist design which is composed of nothing more than a

MOSFET gain-boost stage into a JFET. The gain can be adjusted between the two stages to control the

amount of clipping, and an output volume is present at the end, and that's it.

The Aion FX version of the Peppermill is a direct adaptation of the original circuit, with one modification:

the addition of a tone control. The original circuit has a R-C lowpass filter right before the volume,

and by making the resistor value adjustable, you end up with a useful tone control without otherwise

affecting the original circuit.

Since the J201 is very difficult to find in TO-92 through-hole format, and many DIY hobbyists are

intimidated by SMD parts, Aion FX offers

so they can be used as through-hole parts.

USAGE

The Peppermill has the following controls:

• Drive controls the volume going into the JFET clipping stage. At higher drive levels, the JFET will

overload and clip the signal.

• Tone is a simple passive low-pass filter that can be adjusted for more or less treble.

• Volume controls the overall output of the effect.

RUNOFFGROOVE PEPPERMILL

J201s in SMD format

that have been pre-soldered to adapters

TABLE OF CONTENTS