3M Multimedia Projector S15 제품 안전 매뉴얼 - 페이지 12

{카테고리_이름} 3M Multimedia Projector S15에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Multimedia Projector S15 15 페이지. Multimedia projector
3M Multimedia Projector S15에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 사양 (2 페이지), 제품 안전 매뉴얼 (13 페이지), 사양 시트 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.

Also, do not install an old or previously used lamp.

1. Remove lamp access door: Please loosen the screw (marked by arrow) (1). Then, unhook the

claws of the lamp door (2), and remove the lamp door (3).

2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (4)

All lamp module screws must be loosened. These screws are self-containing screws that

cannot be removed from the lamp module or access door.

3. Remove lamp module: Slowly pick up the lamp module by the handles. (5)

4. Insert lamp module: Carefully insert (5) the new lamp module. Ensure that it is fully seated.

Tighten the lamp module retaining screws (4) to secure the lamp module in place.

Optional Lamp: 78-6969-9812-5 (Contact 3M customer Service.)

Insert the hinge tabs on the bottom of the lamp access door (6), then

two claws (7)

Reset the lamp operation hours. See "Reset Lamp Hours" for details.

(1) Screw marked

by arrow

(2) Claws

(3) Lamp access door

Note

(4) Screws marked

by arrow

(5) Handles

3M™ Multimedia Projector S15i Product Safety Guide

push the center point of

(6) Tab

(7) Center point of

claws