aion Lab L4 BASS PREAMP 매뉴얼 - 페이지 16

{카테고리_이름} aion Lab L4 BASS PREAMP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion Lab L4 BASS PREAMP 20 페이지.

DRILL TEMPLATE INSTRUCTIONS

Cut out the drill template on the following page, fold the edges and tape it to the enclosure. Before

drilling, it's recommended to first use a center punch for each of the holes to help guide the drill bit.

Ensure that the template is printed at 100% or "Actual Size". You can double-check this by measuring the

scale on the printed page with a ruler or calipers.

The LEDs are sized for plain LEDs with no bezel, mounted directly to the PCB. If you don't have a 5mm

bit for the bypass and channel LEDs, use 7/32". If you don't have a 3mm bit for the limit LED, use 1/8".

Important: Due to the high number of PCB-mounted parts, it's crucial that the drilling be accurate. Since

the PCB uses slotted holes for the toggles, there's not a lot of room for error.

If the toggles don't align to the PCB, you can always drill one step larger (9/32") to allow a little more

room correct any errors. The toggle switch washer and nut will still fully cover the hole.

L4 BASS PREAMP