aion Lab Series 매뉴얼 - 페이지 13

{카테고리_이름} aion Lab Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion Lab Series 20 페이지.
aion Lab Series에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지), 매뉴얼 (20 페이지)

BUILD NOTES, CONT.

Channel 1 midrange and volume potentiometer values

The Lab Series amplifier used 2.5kA potentiometers for both Midrange and Volume of channel 1. This

is a non-standard value today and not available from any standard parts suppliers. Tayda Electronics

carries 2kA, which is certainly close enough and will work fine in this circuit. But in the new version of

the L5, we included parallel and tapering resistors on the PCB so standard pot values could be used.

For the midrange pot, we recommend using 5kA, with a 5k1 resistor in parallel (R7). Since it's wired as a

variable resistor, this drops the resistance value to 2.5k and only steepens the curve slightly.

The volume pot is wired as a true potentiometer with all three terminals used, so it's a little more

complicated. For this, it's recommended to use a 10kB pot with a 2k7 resistor (R11) between pins 2 and

3 and a 1k resistor (R12) between pins 1 and 2. This will give a good approximation of a 2.5k pot, and the

resulting taper will be very close to logarithmic.

LM13700 vs. CA3080

Our original L5 Preamp project used CA3080s as in the original amp. These have been discontinued for

a long time, and while they have been reissued and are not terribly hard to find, they are expensive.

The LM13700 is essentially a dual version of the CA3080/CA3094 and is still readily available. Since the

L5 circuit uses two CA3080s, it seemed like a good opportunity to replace them with a single LM13700.

The only change that this required was to add a second 100k resistor (R77) to cut the compressor LED's

voltage in half, since the LM13700's I

pin sits at twice the voltage of the CA3080's pin. This extra

ABC

resistor prevents the LED from staying on all the time, which was the only side-effect of substituting the

LM13700 in place of the CA3080.

Bypass PCB component orientation

Due to the height of the DC converter and electrolytic capacitors, the components on the switching PCB

are mounted on the bottom, the same side as the footswitch. This is in contrast with most other Aion FX

projects where the switch is mounted on the bottom of the switching sub-board and the components

face up. Components are always mounted to the side with the silkscreen footprint.

L5 PREAMP