Blue Angel Pumps 75SW 사용 설명서 및 부품 설명서 - 페이지 7

{카테고리_이름} Blue Angel Pumps 75SW에 대한 사용 설명서 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Angel Pumps 75SW 12 페이지. Sewage pump

페이지 인쇄

INSTALLATION MANUAL

TROUBLESHOOTING CHART (CONT'D)

Symptoms

Possible Cause(s)

Pump trips GFCI

1. Bad GFCI

2. Bad pump

Pump operates

1. Worn bearings

noisily or vibrates

2. Impeller broken

excessively

3. Piping attachments to building

structure too rigid or too loose

Pump will not

1. Switch

shut off

2. Switch obstructions

3. Restricted discharge (obstruction in

piping)

4. Excessive inflow or pump not

properly sized for application

Pump operates

1. Low supply voltage

but delivers little

2. Inlet clogged

or no water

3. Broken impeller

4. Pump not properly sized for

application

5. Check valve stuck closed or

installed backwards

6. Shut off valve closed

ROUTINE MAINTENANCE

The pump should be inspected 3-4 times per year for pump movement or buildup of debris on the switch or float. Reposition

pump if it has moved. Remove any debris that could interfere with the operation of the switch. Lack of proper routine maintenance

will void warranty.

• Make sure the pump is plugged in to a working ground fault circuit interrupter (GFCI) outlet and the cord is in good shape. In

damp areas, GFCI breakers may trip, effectively shutting off the effluent pump. Check in on your sewage pump and reset the

GFCI if necessary.

• Ensure the pump is standing upright. Vibrations during operation can cause it to fall or tilt onto one side. This can jam the float

so it can't activate the pump.

• Pour a bucket of water into the pit to make sure the pump starts automatically and the water drains quickly once the pump is

on. If the pump doesn't start, have it serviced or replaced.

• Replace the tether switch every two (2) years. This maintenance will reduce the risk of improper pump operation, switch failure

and/or flooding.

Suggested Remedies

1. Contact an electrician to replace GFCI

2. Replace pump

1. Replace pump

2. Replace pump

3. Install rubber coupling (available at local hardware stores) to isolate

pump vibration from discharge plumbing

1. Replace tether switch

2. Remove obstruction to verify free motion of switch

3. Remove obstruction from discharge piping

4. Recheck all sizing calculations to determine proper pump size

1. Contact an electrician

2. Remove debris

3. Replace pump

4. Recheck all sizing calculations to determine proper pump size

5. Remove and examine check valve for proper installation and free

operation

6. Open valve