Blue Angel Pumps BSP15 사용 설명서

{카테고리_이름} Blue Angel Pumps BSP15에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Angel Pumps BSP15 13 페이지. 12 volt standby sump pump

페이지 인쇄

Operating Instruction and Parts Manual

Description

The BSP15is a battery operated back-up

sump pump. It does not replace a regular

pump. It is designed to provide protection

in the event household electrical power

fails.

Safety Guidelines

This manual contains information that is

very important to know and understand.

This information is provided for SAFETY

and to PREVENT EQUIPMENT PROBLEMS.

To help recognize this information,

observe the following symbols.

Danger indicates

an imminently

hazardous situation which, if not avoided,

will result in death or serious injury.

Warning indicates

a potentially

hazardous situation which, if not avoided,

could result in death or serious injury.

Caution indicates a

potentially

hazardous situation which, if not avoided,

may result in minor or moderate injury.

Notice indicates

important

information, that if not followed, may

cause damage to equipment.

General Safety

Information

Do not use to pump

flammable or explosive

fluids such as gasoline, fuel

oil, kerosene, etc. Do not use

in a flammable and/or explosive

atmosphere. Pump should only be used to

pump clear water. Fatal injury and/or

property damage could result.

If the basement has water or

moisture on the floor, do not

walk on wet area until all

REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or

maintain the product described. Protect yourself and others by observing all safety information. Failure to

comply with instructions could result in personal injury and/or property damage! Retain instructions for

future reference.

12 Volt Standby

Sump Pump

power is turned off. If the shutoff box is

in the basement, call an electrician.

Remove pump and either repair or

replace. Failure to follow this warning

could result in fatal electrical shock.

qualified electrician.

Do not expose battery to

sparks or flames as an

explosion or fire could

result.

acid is corrosive. Avoid

spilling on skin or clothing.

Eye protection must be worn

when handling the battery.

the primary sump pump discharge (see

Figure 1)

required.

clear water. This pump is not designed to

handle effluent, salt water, brine, laundry

discharge or any other application which

may contain caustic chemicals and/or

foreign materials. Pump damage may

occur if used in these applications and

will void warranty.

Battery Requirements

1. Use only a new fully charged 12 volt

deep cycle battery. Electrolyte level

must be checked and maintained in

accordance with manufacturer's

guidelines.

2. Battery sizes that will fit into the

battery box are 24C, 24VCM, 27C,

27CM and 27F.

3. Battery recharge time will be

different at each installation. Under

normal conditions it will take two to

four days to bring a deep cycle

battery back to full charge after it has

All wiring must be

performed by a

Installation

several hours. Before disabling your

main pump, have ready an appropriate

means of evacuating the sump.

Battery

1. Turn power to main pump off.

2. Pump must be installed using 1

A check valve

must be used on

A ground fault

circuit interrupter is

This pump must only

be used to pump

Figure 1

3. Measure and cut discharge pipe so

4. Check the fit of the components

been discharged. If electrical power to

the house is lost more than once a

week, consider keeping a spare, fully-

charged battery to replace an

exhausted battery for the standby

sump pump.

Installation of this

unit may take

" rigid PVC piping. A check valve

(not included) must be installed

between the ESP's tee and the main

pump (see Figure 1).

4 inch min.

Check

valve

that back-up pump is a minimum of 1

inch above the main pump. This will

allow main pump to operate normally

(see Figure 1).

before permanently attaching. Using

PVC cement, glue tee in place. Note

351204-002 1/07

BSP15

" or

1 inch

min.