Blue Aura Blackline PH 1 매뉴얼 - 페이지 5

{카테고리_이름} Blue Aura Blackline PH 1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Aura Blackline PH 1 8 페이지. Phono pre-amplifer

Making Connection

INPUT:

Using the stereo pair of RCA/Ground Phono cables that

connect to your existing Turntable or Record Player,

connect the white RCA plug into the white (L) input

socket. Then connect the red RCA plug into the red

input socket (R).

GND - Where available.

Loosen the GND (Ground) terminal with your fingers

and insert the fork connector on the end of your ground

wire of your RCA Phono cables from your turntable or

record player under the screw terminal. Then tighten

the GND terminal securely by hand. Do not use tools

as this may overtighten and strip the threads.

If your ground wire does not have a fork connector

on the end, simply strip 5mm of insulation off the end

of the ground wire and twist the wire strands tightly.

You can then wrap the ground wire around the GND

terminal and tighten securely. The proper connection of

the ground wire is essential to prevent any hum through

your sound system.

www.blueaura/information

CARTRIDGE TYPE:

Refer to the instructions or specifications that came

with your turntable or record player to determine which

cartridge type your player uses.

If your turntable uses a Moving Magnet type cartridge,

set the CARTRIGDE TYPE switch to 'MM'.

If your turntable uses a Moving Coil type cartridge, set

the CARTRIGDE TYPE switch to 'MC'.

OUTPUT:

Using a stereo pair of high quality standard RCA audio

cables, connect the white RCA plug into the white (L)

output socket. Then connect the red RCA plug into the

red output socket (R).

Then connect the other end of your RCA cables to a

suitable Line Input (AUX/CD/TAPE) on your existing

Amplifier, Receiver, Mixer or other such music player.

Page | 5