DNF Controls 2MCE-24P 사용자 설명서 - 페이지 6
{카테고리_이름} DNF Controls 2MCE-24P에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DNF Controls 2MCE-24P 19 페이지. Two machine, cuts only editor with 24p editing capability
페이지 인쇄f.
SET THE RECORD DELAY
1)
2)
3)
4)
g.
SET THE RECORD MODE
1)
2)
3)
4)
h.
SET THE VIDEO STANDARD
1)
2)
3)
4)
i.
SET PREROLL VALUE
1.
2.
3.
Installation is complete.
6
2MCE-24P, Two Machine, Cuts Only Editor
Press [MENU].
The MENU key indicator will turn on.
Turn
the
wheel until "RECORD
Enter Record Command latency (delay) time in frames
keypad.
(Typical value for SONY BVW75 is 3 frames.)
Press
[ESC]
to exit the SETUP MENU.
The MENU key indicator will turn off.
Press [MENU].
The MENU key indicator will turn on.
Turn the wheel until
"REC: ="
Press
[MENU]
to toggle between LOCKOUT, ASSEMBLE, CRASH
INSERT record modes.
In INSERT mode, press the "SOFTKEYS" to select Video, Audio1, Audio2,
Audio3 or Audio4.
NOTE: The 5 "SOFTKEYS" are located just below the Display.
Press
[ESC]
to exit the setup menu.
Press [MENU]. The menu indicator will turn ON.
Turn the wheel until "Video Standard:" is displayed.
Press the softkey (a key underneath the desired standard: 24P, NTSC or PAL) to
select a video standard to perform edits in.
Press [ESC] to exit the setup menu.
Press
[SHIFT]
+ [PREROLL]. The display will show the current Preroll
Value.
Enter the desired Preroll Value
show the entered value.
Press
[PREROLL]
to save the current value and
OR
Press
[ESC]
to exit without saving.
DELAY="
is displayed.
using the numeric
is displayed.
Indicator will turn off.
using the numeric
keypad. The display will
exit.
and