DNF Controls 4000CL-O 사용자 설명서 - 페이지 7
{카테고리_이름} DNF Controls 4000CL-O에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DNF Controls 4000CL-O 19 페이지. 400 video clip fast access system with odetics protocol
페이지 인쇄7.
LEARN A CLIP OR CLIP COMBINATION
a. Load a clip on the desired VTRs (See Section 4, "LOAD A CLIP").
b. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad. The selected Cue Point number is shown
on the bottom line of the display.
c.
Press [SHIFT] + [MARK] to start the LEARN. The first line of the display will show
"Select VTRs:" The second line of the display will show "Mark-Lrn, ESC-cancel."
d. Press VTR [1], [2], [3] or [4] to select the VTR to be learned into the current Cue Point. If the
VTRs are ganged, select one VTR that is part of the Gang. The rest of the Gang will be
learned automatically.
e.
Press [MARK] to complete the LEARN.
OR
Press [ESC] to exit without LEARNING.
The ST300 will: LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and current IN
time to the selected Cue Point.
8.
RECALL A CLIP OR CLIP COMBINATION
a.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press [LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips to
the Learned time, then set the Learned GANG mode.
9.
RECUE THE CURRENTLY LOADED CLIP
Press [RECUE]. If an IN Point is marked (the IN indicator is on), the clip will RECUE to the IN
Point.
If the IN point is not marked, the clip will RECUE to the start of the clip.
OR
Press [SHIFT] + [RECUE].
a.
Enter the desired time to search to using the ST300's numeric keypad.
b. Press [ENTER] to search to the entered time.
OR
Press [ESC] to exit without searching.
7
4000CL-O, 400 Clip Fast Access System, Odetics Protocol