DNF Controls 4000CL-MAV-PBIO 사용자 설명서 - 페이지 11

{카테고리_이름} DNF Controls 4000CL-MAV-PBIO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DNF Controls 4000CL-MAV-PBIO 20 페이지. 250 clip fast access system with peripheral bus interface option for sony mav-555 video servers
DNF Controls 4000CL-MAV-PBIO에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

13. SETTING THE IN (OUT) POINT

MARKING THE IN (OUT) POINT

NOTE: When manually entering IN and OUT points, they are always marked based on

tape time, not LTC, no matter what time mode is selected.

VIEWING THE IN (OUT) POINT

CLEARING AN IN (OUT) POINT

Press and hold [DEL] then press and release [IN] ([OUT]).

The IN (OUT) indicator turns off.

14. TRIM CLIPS

LOAD the clip to be trimmed.

Mark IN and OUT points as described above.

Press [SHIFT] + [CLIP LIST]. The display prompts "Enter new file name."

Enter new file name (up to 8 characters) using the numeric keypad.

Press [ENTER] or [LOAD] to save the new CLIP ID.

Press [ESC] to exit without saving.

If the saving is successful, the new clip is created. The beginning of the clip is the

marked IN point and the end of the clip is the OUT point. The new clip can be loaded

using the CLIP LIST function. Upon saving the new clip, marked IN and OUT points are

cleared.

NOTE: Do not create trimmed clips with a duration of less than 18 frames.

11 4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option

Press [IN] ([OUT]). The IN (OUT) indicator turns on.

The display shows: "IN (OUT) xx:xx:xx:xx," where xx:xx:xx:xx is the saved

time.

Press [SHIFT] + [IN] ([OUT]) to manually enter a new IN (OUT) time.

Press [ENTER] to save the entered time.

Press [ESC] to exit without saving.

When the IN (OUT) indicator is on,

Press [IN] ([OUT]) to view the existing IN (OUT) Point.

While viewing the IN (OUT) Point:

Press [MARK] to overwrite the saved time with the current time.

Press [RECUE] to search to the IN (OUT) point.