DNF Controls 4000CL-MAV-PBIO 사용자 설명서 - 페이지 13
{카테고리_이름} DNF Controls 4000CL-MAV-PBIO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DNF Controls 4000CL-MAV-PBIO 20 페이지. 250 clip fast access system with peripheral bus interface option for sony mav-555 video servers
DNF Controls 4000CL-MAV-PBIO에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)
페이지 인쇄13. VIEW CONTENTS OF CUE POINT
a.
Use [NEXT CUE] or [LAST CUE] to access Cue Point.
Contents loaded at this Cue Point (CLIP ID) will be displayed.
OR
b.
Use numeric keypad to enter Cue Point number.
Press [ENTER].
Contents are displayed.
14. TRANSFERRING CUELIST
a.
TRANSMIT CUE LIST FUNCTION
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a
PC, using the provided utility software on the PC, or to another ST300.
1)
2)
13 4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option
TO TRANSMIT CUE POINTS TO THE ST300
a)
Connect the VTR4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300, using an RS422 9-pin cable with TX
and RX lines crossed.
(A "turnaround" cable)
b)
Press [MENU] and scroll the wheel to "Transmit CUE List?
YES=Enter, Exit=ESC."
c)
Press [ENTER] to start transmitting. The Display shows "Waiting to
transmit."
d)
When the Receiver is ready, transfer starts automatically.
The Display now shows "Transmitting cuelist."
e)
After the transfer is over, the display shows "Transfer is over" for one
second, then shows "Waiting to transmit" again.
f)
Connect another ST300 to transmit the list again.
OR
Press [ESC] twice to exit.
TO TRANSMIT CUE POINTS TO THE PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using a RS422 to RS232 adapter.
b)
Repeat steps b-f of the TO TRANSMIT CUE POINTS TO THE ST300
section.