Aion Electronics ASTERIA MK. III 매뉴얼 - 페이지 5

{카테고리_이름} Aion Electronics ASTERIA MK. III에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aion Electronics ASTERIA MK. III 10 페이지.

BUILD NOTES

Using SMD JFETs

The MPF4393 JFET is no longer available from the original manufacturer in through-hole format.

This PCB uses a hybrid through-hole/SMD outline for each JFET. An extra "G" (gate) pad is included to

accommodate the MMBF4393 surface-mount version without the need for adapters.

SMD JFETs should be oriented as follows:

All surface-mount JFETs use the same pinout, so this configuration will fit any type that we're aware

of. However, always check the datasheet if you're uncertain—they're difficult to desolder if you make a

mistake.

MPF4393s from Aion FX

We have a large quantity of

through-hole MPF4393

and should be able to provide them in hobbyist

quantities for the foreseeable future. They are available in sets of 5. They are manufactured by ON

Semiconductor, the same as those used in the original Catalinbread pedal. They test in the same range

and will perform identically.

Setting bias trimmers TR1 and TR2

Trimmers TR1 and TR2 allow adjustment of the gain of the two main amplifier stages. According to

Catalinbread's customer support (relayed in

this thread at The Gear

Page) the trimmers are set at noon

during manufacturing. In the unit we traced, they were both set to zero, so it's possible they changed

this practice at some point.

Whatever the case, start with each trimmer to noon and then adjust to taste. Setting it lower will

increase the gain and setting it higher will reduce the gain.

ASTERIA PREAMP DRIVE MK. III