Aion Electronics Isotope 매뉴얼 - 페이지 6

{카테고리_이름} Aion Electronics Isotope에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aion Electronics Isotope 9 페이지.

DRILL TEMPLATE

Cut out this drill template, fold the edges and tape it to the enclosure. Before drilling, it's recommended

to first use a center punch for each of the holes to help guide the drill bit.

Ensure that this template is printed at 100% or "Actual Size". You can double-check this by measuring

the scale on the printed page.

Top jack layout assumes the use of closed-frame jacks like the

open-frame jacks, please refer to the Open-Frame Jack Drill Template for the top side.

LED hole drill size assumes the use of a

size accordingly if using something different, such as a 3mm bezel, a plastic bezel, or just a plain LED.

INCH

ISOTOPE AMP OVERDRIVE

5mm LED

bezel, available from several parts suppliers. Adjust

125B

0.625"

ø3/8"

ø1/2"

OUT

MASTER

x: -0.65, y: +1.71

ø9/32"

BASS

x: -0.65, y: +0.41

ø9/32"

CENTER (0,0)

LED

FOOTSWITCH

x: -0.775, y: -1.20

x: 0, y: -1.20

ø5/16"

ø15/32"

Switchcraft

111X. If you'd rather use

ø3/8"

DRIVE

x: 0.65, y: +1.71

ø9/32"

TREBLE

x: 0.65, y: +0.41

ø9/32"