Aion Electronics THULCANDRA 매뉴얼 - 페이지 2
{카테고리_이름} Aion Electronics THULCANDRA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aion Electronics THULCANDRA 9 페이지. A mid-gain overdrive with three different tone controls
페이지 인쇄
TABLE OF CONTENTS
1 Project Overview
2 Introduction & Usage
INTRODUCTION
The Thulcandra Boost/Overdrive is an adaptation of the Xotic Soul Driven, a cousin of the classic AC
Booster with roots in the Tube Screamer family, originally released in collaboration with Allen Hinds.
This is an original trace by Aion FX.
The Soul Driven replaces the tone section of the AC/RC Booster circuit with a gyrator-based bass boost
stage that emphasizes the 120Hz frequency. Using internal DIP switches, four bass boost settings are
available: flat, +2.4dB, +3.6dB and +6dB.
The "Mid Boost" control is similar to the Zendrive's Voice control or the Timmy's Bass knob, varying
the resistor in the R-C filter to ground from the op-amp clipping stage. This has the effect of raising or
lowering the bass cutoff frequency as well as changing the overall gain ratio.
The Thulcandra project is faithful to the original, with the exception that the DIP switch has been
replaced by a potentiometer to allow fine control over the amount of bass. (The DIP switch just selects
between four pre-set resistor values, and it's likely due to space considerations that they made it an
internal control rather than an external potentiometer.)
USAGE
The Thulcandra has the following controls:
• Gain controls the amount of gain in the op-amp clipping stage.
• Treble is a passive treble-cut filter similar to the one found in the RAT, Zendrive and Timmy.
• Bass is an active bass-boost at 120 Hz, from flat at minimum position to +6dB at maximum.
• Mid Boost raises or lowers the cutoff frequency of the clipping stage.
• Volume controls the overall output of the effect.
THULCANDRA BOOST/OVERDRIVE
9 Licensing
2